해외표준 상세정보
관심표준 등록 : 표준업데이트 시 알림서비스
제공형태 더보기-
표준
판매
ISO 17678:2019
Milk and milk products — Determination of milk fat purity by gas chromatographic analysis of triglycerides- 발행일 : 2019-05-28
- 발행기관 : ISO
상세정보
분야 | ISO/TC 34/SC 5 : Milk and milk products |
---|---|
적용범위 | This document specifies a reference method for the determination of milk fat purity using gas chromatographic analysis of triglycerides. The method utilizes the differences in triglyceride fingerprint of milk fat from the individual triglyceride fingerprints of other fats and oils to determine samples which are outside the range normally observed for milk fat. This is achieved by using the defined triglyceride formulae based on the normalized weighted sum of individual triglyceride peaks which are sensitive to the integrity of the milk[6][7]. The integrity of the milk fat can be determined by comparing the result of these formulae with those previously observed for a range of pure milk fat samples[12]. Both vegetable fats and animal fats such as beef tallow and lard can be detected. The method is applicable to bulk milk, or products made thereof, irrespective of the variation in common feeding practices, breed or lactation conditions. In particular, the method is applicable to fat extracted from milk products purporting to contain pure milk fat with unchanged composition, such as butter, cream, milk and milk powder. Because a false-positive result can occur, the method does not apply to milk fat related to these circumstances: a) obtained from bovine milk other than cow's milk; b) obtained from single cows; c) obtained from cows whose diet contained a particularly high proportion of vegetable oils such as rapeseed, cotton or palm oil, etc.; d) obtained from cows suffering from serious underfeeding (strong energy deficit); e) obtained from colostrum; f) subjected to technological treatment such as removal of cholesterol or fractionation; g) obtained from skim milk, buttermilk or whey; h) obtained from cheeses showing increased lipolysis; i) extracted using the Gerber, Weibull?Berntrop or Schmid?Bondzynski?Ratzlaff methods, or that has been isolated using detergents (e.g. the Bureau of Dairy Industries method). With the extraction methods specified in i), substantial quantities of partial glycerides or phospholipids can pass into the fat phase. NOTE 1 In nature, butyric (n-butanoic) acid (C4) occurs exclusively in milk fat and enables quantitative estimations of low to moderate amounts of milk fat in vegetable and animal fats to be made. Due to the large variation of C4, for which the approximate content ranges from 3,1 % fat mass fraction to 3,8 % fat mass fraction, it is difficult to provide qualitative and quantitative information for foreign fat to pure milk fat ratios of up to 20 % mass fraction[11]. NOTE 2 In practice, quantitative results cannot be derived from the sterol content of vegetable fats, because they depend on production and processing conditions. Furthermore, the qualitative determination of foreign fat using sterols is ambiguous. NOTE 3 Due to special feeding practices such as those related to c) and d), false-positive results have sometimes been reported for milk from certain Asian regions[15]. Moreover, grass-only diets such as mountain and, in particular, highland pasture feeding sometimes cause false-positive results, which can be substantiated by a content of conjugated linoleic acid (C18:2 c9t11) of ≥ 1,3 % fatty acid mass fraction[16][17]. Nevertheless, results conforming to the criteria of milk fat purity specified in this document are accepted, even if samples were undoubtedly produced under conditions reported in this note, including those described in h). NOTE 4 In cases where a positive result is suspected to be caused by circumstances related to c) or d), another analytical method, such as fatty acid or sterol analysis, can be applied to confirm the finding. Due to similar or increased limitations (e.g. as described in NOTE 1 and NOTE 2), a negative result obtained by another method is not appropriate to contrastingly confirm milk fat purity. |
국제분류(ICS)코드 | 67.100.10 : 우유 및 유제품 |
페이지수 | 24 |
Edition | 2 |
이력정보
No. | 표준번호 | 표준명 | 발행일 | 상태 |
---|---|---|---|---|
1 | ISO 17678:2019상세보기 | Milk and milk products — Determination of milk fat purity by gas chromatographic analysis of triglycerides | 2019-05-28 | 표준 |
2 | ISO 17678:2010상세보기 | Milk and milk products — Determination of milk fat purity by gas chromatographic analysis of triglycerides (Reference method) | 2010-02-02 | 구판 |
관련상품
- 관련상품이 존재하지 않습니다.
다른 사람이 함께 구입한 상품
- ASTM D5996-16 REDLINE - Standard Test Method for Measuring Anionic Contaminants in High-Purity Water by On-Line Ion Chromatography
- ASTM F1593-08(2016) - Standard Test Method for Trace Metallic Impurities in Electronic Grade Aluminum by High Mass-Resolution Glow-Discharge Mass Spectrometer (Withdrawn 2023)
- ASTM D2712-20 REDLINE - Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography
- ASTM F1710-08(2016) - Standard Test Method for Trace Metallic Impurities in Electronic Grade Titanium by High Mass-Resolution Glow Discharge Mass Spectrometer (Withdrawn 2023)
- ASTM D7653-18 REDLINE - Standard Test Method for Determination of Trace Gaseous Contaminants in Hydrogen Fuel by Fourier Transform Infrared (FTIR) Spectroscopy
추천 상품
- IEC TS 63134:2020 - Active assisted living (AAL) use cases
- IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification
- KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs)
- KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs)
- KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스
제공형태 닫기
PDF :
직접 파일 다운로드 및 인쇄(마이페이지 확인)보안PDF :
직접 파일 다운로드 및 인쇄(마이페이지 확인)* 단, 파일이동 및 복사 불가, 1회 다운로드 및 인쇄가능PRINT :
인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)BOOK :
인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)ZIP :
압축파일형태로 제공 (PDF, HTML, TXT, XLS 등으로 구성), 직접 파일 다운로드(마이페이지 확인)CD/DVD :
직접 파일 다운로드 및 인쇄(마이페이지 확인)DB :
별도 정보 제공HARDCOPY :
해외 배송 상품, 최대 3주 소요바인더 :
바인더 우편발송, 2~3일 소요온라인구독 :
WEB 접속 후 실시간 열람, 출력(1년간)