한국표준정보망

회원가입 로그인 비회원(주문조회) 장바구니 이용안내

English
메뉴
검색 마이페이지 장바구니0

QUICK

닫기

TOP

해외표준 상세정보

관심표준 등록 : 표준업데이트 시 알림서비스

제공형태 더보기

  • KS

    구판

    판매

    ASTM D2850-23 REDLINE

    Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils
    • 발행일 : 2023-02-01
    • 발행기관 : ASTM
    즐겨찾기 장바구니 담기
    닫기

    상품이 장바구니에 담겼습니다.

    장바구니로 이동

    • [영어]PDF(레드라인) 131,600원

    • [영어]PRINT(레드라인) 131,600원

  • 레드라인이란?

    최신표준과 직전 구판표준의 변경내용을 포함하고 있는 버전. 구입 시 최신표준과 레드라인 두 개 파일을 제공합니다.

상세정보

분야
적용범위

1.1?This test method covers determination of the strength and stress-strain relationships of a cylindrical specimen of either intact, compacted, or remolded cohesive soil. Specimens are subjected to a confining fluid pressure in a triaxial chamber. No drainage of the specimen is permitted during the application of the confining fluid pressure or during the compression phase of the test. The specimen is axially loaded at a constant rate of axial deformation (strain controlled).

1.2?This test method provides data for determining undrained strength properties and stress-strain relations for soils. This test method provides for the measurement of the total stresses applied to the specimen, that is, the stresses are not corrected for pore-water pressure.

Note 1:?The determination of the unconfined compressive strength of cohesive soils is covered by Test Method D2166/D2166M.

Note 2:?The determination of the consolidated, undrained strength of cohesive soils with pore pressure measurement is covered by Test Method D4767.

1.3?All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.3.1?The procedures used to specify how data are collected/recorded or calculated in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.

1.4?Units?The values stated in SI units are to be regarded as the standard. The values given in parentheses are mathematical conversions to inch-pound units, which are provided for information only and are not considered standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.

1.4.1?The converted inch-pound units use the gravitational system of units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs. The slug unit is not given, unless dynamic (F = ma) calculations are involved.

1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
국제분류(ICS)코드
페이지수 7
Edition 23

이력정보

No. 표준번호 표준명 발행일 상태
1 ASTM D2850-25상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2025-03-15 표준
2 ASTM D2850-25 REDLINE상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2025-03-15 표준
3 ASTM D2850-24상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2024-05-01 구판
4 ASTM D2850-24 REDLINE상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2024-05-01 구판
5 ASTM D2850-23상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2023-02-01 구판
6 ASTM D2850-23 REDLINE상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2023-02-01 구판
7 ASTM D2850-15 REDLINE상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2015-11-15 구판
8 ASTM D2850-15상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2015-11-15 구판
9 ASTM D2850-03a(2007)상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils 2007-09-15 구판
10 ASTM D2850-03a상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial CompressionTest on Cohesive Soils 2003-11-01 구판
11 ASTM D2850-03상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial CompressionTest on Cohesive Soils 2003-02-10 구판
12 ASTM D2850-95(1999)상세보기 Standard Test Method for Unconsolidated-Undrained Triaxial CompressionTest on Cohesive Soils 1999-01-01 구판

관련상품

  • 관련상품이 존재하지 않습니다.

다른 사람이 함께 구입한 상품

추천 상품

제공형태 닫기

  • PDF :

    직접 파일 다운로드 및 인쇄(마이페이지 확인)

  • 보안PDF :

    직접 파일 다운로드 및 인쇄(마이페이지 확인)* 단, 파일이동 및 복사 불가, 1회 다운로드 및 인쇄가능

  • PRINT :

    인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)

  • BOOK :

    인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)

  • ZIP :

    압축파일형태로 제공 (PDF, HTML, TXT, XLS 등으로 구성), 직접 파일 다운로드(마이페이지 확인)

  • CD/DVD :

    직접 파일 다운로드 및 인쇄(마이페이지 확인)

  • DB :

    별도 정보 제공

  • HARDCOPY :

    해외 배송 상품, 최대 3주 소요

  • 바인더 :

    바인더 우편발송, 2~3일 소요

  • 온라인구독 :

    WEB 접속 후 실시간 열람, 출력(1년간)